How To Put Moulding On Kitchen Cabinets

By alexa 23 Aug, 2017 Post a Comment

With the measuring tape measure the width and depth. Hold up the crown molding on the sides of the cabinet.

How To Add Crown Molding To The Top Of Your Cabinets Kitchen

Place it flush along the side of the cabinet.

How to put moulding on kitchen cabinets. Many cabinet companies sell pre cut molding styles to fit the cabinets for sale or you can purchase molding and make your own measurements and cuts. The points of the mitered end should be flush with the corners. The first length of molding will butt directly against a wall on one end with the other end either meeting the next piece at an inside or outside corner along the cabinets.

This also eliminates the need to fill nail holes. Instructions measure the nailing strips. You can add molding to your cabinets in the same way you would install molding on your wall.

For the sleekest appearance. Add a 1 x 1 1 2 inch piece of wood called a nailer along the top edge of the cabinets. Aligning the bottom moulding edge with the top of the cabinet frame should eliminate curves and sags.

To cut the butt joint simply place the molding into the miter saw and make a straight cut. Apply wood glue to the riser and attach it to the nailer. Using a miter saw set at a 45 degree angle cut pieces of baseboard type molding.

Cut the nailing strips. Miter cut the front piece to length and nail in place against the mounting board with the bottom edge even with the top of the cabinet frame. Measure the crown molding lower edge.

Measure and mark the molding with the length of the front piece of baseboard starting from the deepest part of the 45 degree cut. Cut the butt joint for the first length of molding. Be sure they re tight against the wall.

As a precaution though check your work immediately to make sure the moulding runs in a straight line. Neither should it be so thin that the trim would easily come off the cabinet nor should it be so thick that the glue starts dripping off the trim. Lay the front.

Run a bead of wood glue down the back of one of the pieces of molding. Spread an even layer of the glue on the trim. Wait till the glue is slightly sticky.

Use a pencil to mark from the inside the correct measurement to cut the crown molding. Add a thin line of the glue on the cabinet area marked with a pencil. Position the nailing strips.

Once the molding is in place enlist a friend s help and slide the cap atop the cabinets. Cut the nailing strips to the cabinet perimeter size. How to install kitchen cabinet crown molding step 1.

Take a piece of crown molding longer than the front of the cabinet and cut a 45 degree angle off one side. Use moderate amount of glue i e. Cut a 45 degree angle off the opposite side.

Then you simply have to nail and glue the molding in place allowing the glue to dry overnight. Attach the crown molding with a cordless driver using 1 1 4 inch screws attached through the back of the cap and into the back edge of the molding.

The Easiest Way To Add Trim To A Cabinet Cabinet Trim Diy